Cypress Chameleon CTM-15X Instrukcja Użytkownika Strona 12

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 15
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 11
© 2009 Cypress Solutions PAD Operation (Revision 1.0)
12 Example Modem PAD Configuration
cmd port 19200 8 n 1 2
It will now be necessary to adjust the baud rate of the terminal application to 19200.
cmd padmode 4/5 PAD client, persistent mode: 4 = UDP, 5 = TCP
cmd padecho 1 Echo data sent by the master device back on the serial port
(default setting, in effect after cmd factory)
cmd padip 100.100.1.2 Sets IP address of field device being polled
cmd padport 5000 Sets port of field device being polled
cmd padfwdc 0 No forwarding character
cmd padfwdl 101 Greater than longest message size
cmd padfwdt 10 Sets the forwarding time to 0.5 seconds idle period
cmd padsvct 15 0 Set connection timeout to 15 seconds, maximum connection timer is disabled
(default settings, in effect after cmd factory)
cmd save Save configuration to modem’s non-volatile memory
cmd pwrmode 2 Power cycle
5.3 Modem PAD Configuration for a SCADA Master Device Polling Multiple
Field Devices in Slave Mode
In this example, a Chameleon modem is connected to a programmable master device intended to poll
multiple field devices in slave mode. The master device is typically a server running a custom SCADA
application and communicates with field devices via a request/response protocol. The slave devices will
only send responses to requests sent.
The modem is connected to a master device at baud rate of 19200 with full hardware flow control. It
receives sentences on its serial port of maximum length 100 bytes (with no common end character) which
are to be sent to multiple slave units at IP addresses 100.100.1.1-100.100.1.10, port 5000. The slave
devices typically respond within 8 seconds. The serial master device requires echoing of data that it sends
to the modem. In this example, the master device requires built-in scripting functionality to perform
predefined actions based on serial port output when in command mode.
Przeglądanie stron 11
1 2 ... 7 8 9 10 11 12 13 14 15

Komentarze do niniejszej Instrukcji

Brak uwag